This article focuses on pan conveyor’s classification and maintenance, you will see many kinds of pan conveyors, you will also know how to do the maintenance for it.

Pan conveyors are generally classified as follows:
1.According to the installation form of the conveyor, it can be divided into fixed type and mobile type;
2.According to the layout of the pan conveyor, it can be divided into horizontal type, horizontal-tilt type, inclined type, inclined-horizon type, horizontal-tilt-horizon type, etc.
3. According to the structural type of the traction member, it can be divided into sleeve roller chain type, stamping chain type, casting chain type, ring chain type and detachable chain type;
4. According to the number of traction chains, it can be divided into single-chain and double-chain;
5. According to the structure type of the bottom plate, it can be divided into slat type (with rib type wave type, no rib wave type, deep rib type, etc.) and flat type (with rib flat type and no rib flat type, etc.);
6. According to the running characteristics of the pan conveyor can be divided into continuous and pulsating;
7. According to the driving method, it can be divided into electric mechanical drive type and hydraulic drive type.
Daily maintenance of the pan conveyor :
1.Keep the equipment clean;
2.Always check and clean the meshing friction parts and lubrication points. Add lubricants in time to ensure good working conditions;
3.Check for looseness at each drive connection. In particular, the bolts of the scraper chain are found to be loose and tightened in time;
4.Check the tension of the scraper chain. When there is a slack phenomenon. Adjust the driven shaft mechanism to make the chain plate tight. If you can no longer adjust, you must remove the extra chain;
5.Always pay attention to the working condition of the reducer. If noise is found, the temperature rise is too high, or there is oil leakage on each sealing surface, it should be disposed of in time. The reducer (the oil hole is inspected at the upper part of the tank. The oil is also drained at the bottom of the tank). After the first refueling, it runs for 100 h. Should be replaced with new oil. Work continuously in the future, change oil every six months; If there is any problems in the rotation. It should be stopped immediately. Carefully check and handle;
6.When the work is finished, stop feeding, stop the residual material on the board and then stop it. Check whether there are any accumulated materials on both sides of the tank before starting each time. After cleaning, turn it on again.