The trommel screen is often used for the screening of powdery materials because of its smooth operation and low noise when sieving materials. The general trommel screens are made of special screens, so the sieve effect is good and the sieve holes are not easy. Blockage, smooth operation and low noise. Trommel screen installation:
1. Pre-buried steel plate.
Before installation, the steel plate should be embedded according to the requirements of the equipment installation drawing, and the upper plane of the embedded steel plate should be placed on the same plane. The pre-embedded steel plates and foot bolts required for installation are provided by the installation unit.
2. Installation of the sieve body.
According to the position of the feeding port and the discharging port of the equipment, the installation position of the screen body is determined.
3. Install the base bracket.
The two ends of the sieve body are mounted on the base bracket by lifting, and the installation angle of the trommel screen body is adjusted to the design angle, and finally fixed welding is performed.
4. Connect the inlet and outlet.
5. Connect the lower bracket sealing plate of the sieve body.
6. Turn the trommel screen cylinder by hand. There must be no excessive resistance or jamming. Otherwise, the cause should be checked and adjusted.
7. After the trommel screen is shipped, if it is installed more than 6 months, the bearing of the large shaft must be removed and cleaned before installation, and new grease (No. 2 lithium grease) must be injected.