Belt sway switch play an important role in belt conveyor, about belt sway switch’s maintenance and repair is gradually pay attention by people. The following content are the solutions about belt sway switch’s repair and maintenance. Hope to it is useful for you.
Firstly, about the steps of the belt sway switch’s repair. 1.Carefully check the appearance of belt sway switch , and make a sure of whether it has crack, what’s more, make sure of whether it has the phenomenon of water in the belt sway switch and whether there are damage surface wiring.
2.You can confirm which level are damaged of the belt sway switch, if you with the central room on the signal. After opening the belt sway switch, please check whether the main spring of belt sway switch is sensitive and whether it can be automatically reset after pulling.
3.Used multimeter to check the inside circuit of belt sway switch clearly, to understand each line is what role, whether there is a wrong connection, loose, virtual connection.
4. Confirm that i the bus box whether the belt sway switch’s line has virtual connection and broken condition, whether the maintenance man can quickly view the address table in the bus box, and the address point on the module.
5.Using the mulimeter to determine the normally closed contacts and opened contacts, what’s more don’t forget to view whether the contacts are in a good condition. If there are damage, maintenance will be needed. After the maintenance, comparing it to signal again. After confirmation, clean the inside and reinstall it. Pay attention to waterproof and dustproof.
Secondly, about the maintenance of the belt sway switch
1.Idler wheel of the belt sway switch’s joystick need to install closely with the belt edge and don’t squeeze and don’t so far, it is convenient to the equipment’s emergency stop or alarm.
2.If there is a lot of dust attached to the periphery of the joystick roller, it needs to be sweep away in time.
3.Observe the wear of the roller at any time, confirmed whether the roller wear more than 2mm, replace according to equipment operation instruction. The locking nut is required locking after replacing the roller. Operating the swinging roller and confirm whether the belt sway switch is in regular work. If it need open the outer books during check or change the wiring or adjustment, be sure to pack the outer box with locking screws after finishing the work , to avoid water and dust, causing accidents.
4.Cultivate the professional and safety awareness of the site staff, people foremost, Quickly and safely improve the working efficiency of the belt conveyor.
Belt sway switch is the main switch on the belt conveyor, users need to pay more attention to the selection and installation, scientific selection, installation and maintenance is to ensure its safe use of the basis .Henan Excellent Company’s belt sway switch can provide accurate selection and follow-up maintenance for customers, and achieve the ideal configuration and high efficiency of belt sway switch