Sidewall Belt conveyor is a conveyance with reference to vertical lift or large inclination Angle, which can be used in coal, cement, mining, metallurgy, chemical industry and other industries. Sidewall belt conveyor consists of the reference of up and down roller, press wheel, slatting and cleaning device, Sidewall belt conveyor, tensioning device and so on.
1、Add shims to the right side of the drive drum of the head (facing the upper bin belt machine), forming a high right and low left, causing the drive pulley to be pseudo-slanted;
2、Increase the special sweeper at the lower belt of the head;
3、Increase "herringbone" sweeper at 30m, 70m, 120m, 150m and 180m behind the head respectively;

sidewall belt conveyor for chemcial industry

4、Make a reasonable sidewall belt conveyor hopper (made by the machine repair section) at the unloading port of the transport chute to prevent coal leakage, and make a movable steel plate above the outside of the hopper (facing the transport chute) to reduce the impact of large pieces of coal or research stones on the "skin" of the hopper;
5、Increase rollers or change to pulleys (DTL80/40/40 belt machine tail pulley) to protect the belt; when using the pulley method, dig out a slot of 1.3m long, 0.6m wide and 0.5m deep at the slope change point, pour a 60cm long I-beam on both sides with 20cm exposed, and cut a 3.8cm wide and 5cm deep opening at the top of the I-beam to facilitate the installation and fixing of the pulley;
6、The whole belt machine increases one set of roller frame (including upper roller frame, upper roller, longitudinal beam, eccentric roller frame, lower roller, outrigger) and anti-running roller every 9 meters; one set of eccentric roller frame is installed every 6 meters;
7、Change 18kg/m rail at the end of the machine to 30kg/m rail, weld the rail with sleepers, and do foundation pouring to fix; rail sleepers are made of I-beam;
8、Fix the pulley at the end of the sidewall belt conveyor;
9、The use of latitude and longitude instrument to determine the center line, with cotton rope from the head to the end of the machine to pull the center line, the center line error should be controlled within 2mm;
10、After the center line is positioned, the middle leg is corrected. Each outrigger is divided into the center point, and then line drop and horizontal correction, line drop correction deviation should be controlled within 2mm, blister requirements in the middle; Note: Because the existing large inclination angle belt machine outrigger overall do base fixed, can be adjusted, can not be completely guaranteed.

Analysis and calculation of chain tension of apron feederss for mineral processing detailed introduction

Application analysis of new double layer banana screen technology